Identification of Pin Polarity and Quality in Crystal Transistors

Date:2026-11-20 Categories:Product knowledge Hits:167 From:Guangdong Youfeng Microelectronics Co., Ltd


(5) Identification between high-frequency and low-frequency tubes

Distinguishing between high-frequency and low-frequency tubes: The cutoff frequency of high-frequency tubes is greater than 3 MHz, while the cutoff frequency of low-frequency tubes is 3 MHz lower. Generally, the two cannot be used interchangeably. Due to the different models of high and low frequency tubes, when their specifications are clear, they can be easily distinguished by referring to relevant manuals. When their logo models are unclear, BVebo can be used to measure the reverse resistance of the emitter junction with a multimeter to distinguish between high and low frequency tubes. diode

Taking NPN type tube as an example, place the multimeter in the R × lk position, connect the black probe to the emitter junction e of the tube, and connect the red probe to the pole b. At this time, the resistance value is generally above several hundred kiloohms. Next, pull the multimeter to the R × lOk high blocking position, with the red and black gauge strokes unchanged, and re measure the resistance value between e and b. If the measured resistance value does not change significantly from the first measured resistance value, it can be determined that the tested tube is a low-frequency tube; If the resistance changes significantly, exceeding 1/3 of the multimeter's full capacity, it can be basically determined that the tested tube is a high-frequency tube.

(6) Detection of high-power semiconductor transistors

The method of using universal decay to detect the electrode, tube type, and performance of low-power transistors is basically applicable to high-power transistors, because the metal shell is known (collector), so the discrimination method is relatively simple.

It should be pointed out that due to the large volume of high-power transistors, the inter electrode resistance is relatively small. If the R × 1k (Ω) range of a multimeter is used to detect the forward resistance between the poles of low-power transistors, it will inevitably cause the ohm pointer to approach zero. This situation is similar to an inter electrode short circuit, making it difficult for the detector to make a judgment. To prevent misjudgment, the R × 1 (Ω) or R × 10 (Ω) range should be used when detecting the forward resistance of the PN junction of high-power transistors. diode



Previous: Classification, Structure, and Principle of MOSFET

Next: No Results

QQChat
ChatWechat
ConsultTelephone
+86-0769-82730331