Identification of Pin Polarity and Quality in Crystal Transistors

Date:2026-11-20 Categories:Product knowledge Hits:161 From:Guangdong Youfeng Microelectronics Co., Ltd


Using the resistance range of a multimeter can identify the polarity of a transistor and assess its quality. When testing small-power transistors, typically the R×100 (Ω) or R×1k (Ω) range is used to avoid damaging the transistor.

(1) Identification of tube type and base

Set the multimeter to the resistance range, selecting the R×1k (or R×100) scale. Connect one probe to a certain electrode (assumed to be the common terminal), and use the other probe to touch the other two electrodes in turn. If both measured resistances are very small (or very large), the first electrode connected is the base. If the two measured resistances are significantly different—one high and one low—the assumed base is incorrect, and another electrode should be tried for re-measurement. Following this method, the common terminal can be identified, which is the base b. diode

After identifying the base (B), connect the red probe of the analog multimeter to the base (B) and the black probe to the other two pins. If the meter readings are all very small (approximately a few hundred ohms), the transistor is an NPN type; otherwise, it is a PNP type.

(2) Identification of Emitter and Collector

After identifying the base and transistor type, determine the emitter and collector. The method is as follows: Take an NPN transistor as an example. Assume one of the remaining two pins is the collector, connect the black test lead (corresponding to the positive terminal of the internal battery) to this pin, and connect the red test lead to the assumed emitter. Then, connect a 100 kΩ or higher resistor across the assumed collector and the already identified base (often hold the b and c pins in hand, using body resistance as a substitute, but avoid touching both pins simultaneously). Record the resistance reading at this point. Next, switch the original assumed collector to the emitter and the original emitter to the collector, then repeat the measurement. Among the two readings, the one with the lower resistance (larger deflection angle) indicates the correct assumption. The pin connected to the black test lead is the collector, and the remaining pin is the emitter. For a PNP transistor, reverse the test leads and use the same method to determine. diode

(3) Identification of Transistor Performance

① Assessing the quality of a transistor: Use a multimeter to measure the forward and reverse resistance of the emitter junction and collector junction. If the readings fall within the normal range, the transistor is still functional; otherwise, it is damaged. diode



Previous: Classification, Structure, and Principle of MOSFET

Next: Identification of Pin Polarity and Quality in Crystal Transistors

QQChat
ChatWechat
ConsultTelephone
+86-0769-82730331